1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
|
#include <assert.h>
#include <cpu/io.h>
#include <drivers/pci.h>
#include <drivers/rtl8139.h>
#include <mmu.h>
#define RBSTART 0x30
#define CMD 0x37
#define IMR 0x3C
struct PCI_DEVICE rtl8139;
uint8_t device_buffer[8192 + 16];
void rtl8139_init(void) {
if (!pci_populate_device_struct(0x10EC, 0x8139, &rtl8139)) {
kprintf("RTL8139 not found :(\n");
return;
}
kprintf("RTL8139 found at bus: %x slot: %x\n", rtl8139.bus, rtl8139.slot);
uint8_t header_type = (pci_config_read32(&rtl8139, 0, 0xC) >> 16) & 0xFF;
assert(0 == header_type);
uint32_t base_address = pci_config_read32(&rtl8139, 0, 0x10);
uint8_t interrupt_line = pci_config_read32(&rtl8139, 0, 0x3C);
kprintf("interrupt_line: %x\n", interrupt_line);
// Turning on the device
outb(base_address + 0x52, 0x0);
// Reset the device and clear the RX and TX buffers
outb(base_address + CMD, 0x10);
for (; 0 != (inb(base_address + CMD) & 0x10);)
;
// Setupt the recieve buffer
uint32_t rx_buffer = (uint32_t)virtual_to_physical(device_buffer, NULL);
outl(base_address + RBSTART, rx_buffer);
// Set IMR + ISR
outw(base_address + IMR, 0x0005); // Sets the TOK and ROK bits high
// Configure the recieve buffer
outl(base_address + 0x44,
0xf | (1 << 7)); // (1 << 7) is the WRAP bit, 0xf is AB+AM+APM+AAP
// Enable recieve and transmitter
outb(base_address + 0x37, 0x0C); // Sets the RE and TE bits high
asm("sti");
}
|
